User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Software ROMB User Manual
36
Refer to the total available capacity under Capacity (GB) in the top right
corner of the Define LD Menu.
The remaining capacity is applied to the second logical drive created using
the same disk drives.
11. Type a number value for the Gigabytes of capacity for your first logical drive
and press Enter.
Your first logical drive appears in the LD View Menu.
Logical Drive 2
To create the second logical drive:
1. Press Ctrl-C to access the Define LD Menu.
2. Choose the RAID Level you want. In the Define LD Menu section, press the
Spacebar to toggle through logical drive types:
• RAID 0 (Stripe)
• RAID 1 (Mirror)
• RAID 5 (Distributed Parity)
• RAID 10 (Stripe/Mirror)
• JBOD (Single Drive)
• SPAN (Concatenated Drives)