User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Chapter 4: RAID Management Utility
33
12. Press Esc to exit to the Main Menu. Press Esc again to exit the Utility.
13. Press Y to restart your computer.
You have successfully created a new RAID logical drive. You must be
partition and format your new logical drive before you can use it.
Two Logical Drives
The following action creates two logical drives on the same set of physical drives.
You can also create one logical drive on a set of physical drives. See “Creating
Logical Drives” on page 30.
Logical Drive 1
To create the first logical drive:
1. From the Main Menu screen, press 2 to display the LD View Menu.
2. Press Ctrl-C to access the Define LD Menu.