User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Software ROMB User Manual
32
The LD name prompt appears.
8. Press Ctrl-Y to open a name field.
If you press any key other than Ctrl-Y, a default name is used and the
process goes to the next step.
9. Type a name for the logical drive and press Enter.
If you leave the field blank and press Enter, a default name is used.
If you chose Fast or Full Initialization in step 5, the Fast Init warning appears.
10. Press Ctrl-Y to accept Initialization.
If you press any key other than Ctrl-Y, the logical drive creation is cancelled.
The Modify Array Capacity option appears.
This procedure creates only one logical drive, therefore skip this option.
11. Press any key other than Ctrl-Y.
Your new logical drive appears in the LD View Menu.