User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Software ROMB User Manual
24
Status – Shows the logical drive’s condition:
Functional – The logical drive is fully operational, and no problems are
present.
Critical – The logical drive is operational, but has lost its fault tolerance. For
RAID 1, 5, or 10, the logical drive contains a failed drive. You must identify
and replace the failed physical (disk) drive.
Offline – The logical drive is no longer operational and the RAID
Management Utility cannot rebuild it. You must identify and replace the failed
drives. Then you can create a new logical drive and copy your data to it from
your backup device.
Migrating – The logical drive is in the process of changing RAID levels and/
or adding one or more physical drives.
Synchronizing – The logical drive is in the process of checking and
correcting data and parity.
Rebuilding – The logical drive is in the process of repairing itself by
reconstructing the data on a failed or removed physical drive.
Initializing – A new logical drive is synchronizing its physical drives and
creating redundant data or parity data.
The BIOS screen displays the following information for JBOD Disks and Serial
ATAPI devices:
Port – SATA port to which the physical drive or Serial ATAPI device is connected.
Model Name – Manufacturer name and model of the drive or device