User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
ROMB Software User Manual
114
Fatal errors or data corruption are constantly reported when reading or
writing to the logical drive
See “The logical drive constantly goes critical or offline during reboot,”
above.
Operating System-Related Issues
The ROMB driver does not appear in Device Manager
The Windows Device Manager may show the ROMB controller under Other
Devices or SCSI and RAID Controllers instead of the Hard Disk Controllers.
Look under Other Devices to see if it lists a RAID Controller. If so, highlight
this listing and click the Properties button then click the Driver tab.
Depending on your version of Windows, choose either Change Driver or
Update Driver. Follow the on-screen prompts to complete installation of the
driver. If Windows asks if you want to test if the device can be removed
safely, click CANCEL. Reboot the system to complete installation of the
driver.
“Inaccessible Boot Device” message appears during floppyless installation
of Windows
You did not press the F6 key at the appropriate time. Reboot the system and
press the F6 key when the message “Press F6 if you need to install third
party SCSI or RAID driver” appears in Windows.
“No Hard Drives Found” message appears during CD-ROM installation of
Windows
You did not press the F6 key at the appropriate time. Reboot the system and
press the F6 key when the message “Press F6 if you need to install third
party SCSI or RAID driver” appears in Windows.
Why can't I see the physical drives on the ROMB Controller under FDISK?
You have not created a logical drive or JBOD yet. If no logical drive or JBOD
has been created, the OS will not recognize physical drive(s) attached to the
ROMB controller.
Why can't I log into WebPAM over the network?
Verify that you have the correct IP address for the Host PC where the ROMB
controller is installed.
If you checked the Local Monitoring Only option when you installed
WebPAM, you can only access WebPAM from the Host PC. To obtain
network access, reinstall WebPAM and be sure you UNcheck the Local
Monitoring Only option. See “Installing WebPAM” on page 5.