User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Chapter 6: Technology
109
RAID 0
A RAID 0 source logical drive can migrate to the following target logical drives:
RAID 1
A RAID 1 Source logical drive can migrate to the following Target logical drives:
RAID 5
A RAID 5 Source logical drive can migrate to the following Target logical drives:
Target Requirements
RAID 0 Add physical drives.
RAID 1 2 physical drives only.
Only a single-drive RAID 0 can migrate to RAID 1 by adding 1
physical drive.
RAID 5 3 physical drives minimum, 6 maximum.
RAID 0 must have less than 6 physical drives.
RAID 10 4 physical drives minimum.
Even number of physical drives.
SPAN One drive only.
Target Requirements
RAID 0 None.
RAID 5 Add physical drives. 3 minimum, 6 maximum.
RAID 10 4 physical drives minimum.
Even number of physical drives.
Target Requirements
RAID 0 None.
RAID 5 Add physical drives. 6 maximum.