Specifications

Release 331 Quadro, NVS, Tesla, & GRID Drivers for Windows - Version 332.50 RN-WQ33250-01_v01 | 23
Known Product Limitations
This section describes problems that will not be fixed. Usually, the source of the problem
is beyond the control of NVIDIA. Following is the list of problems and where they are
discussed in this document:
 “System Should not Enter Sleep/Hibernate Mode With SDI Capture in Progress” on
page 23
 “Once Installed, the SDI Capture Driver Release Must Always Match the Graphics
Driver” on page 24
 “Some APIs do not Report Total Available Graphics Memory Correctly” on page 24
 “Using HDMI/DisplayPort Audio with Displays that have a High Native Resolution”
on page 26
 “Using HDMI/DisplayPort Displays that do not Support Audio” on page 26
 “Using HDMI/DisplayPort Audio in Dualview or Clone Mode Configurations” on
page 27
 “GPU Runs at a High Performance Level (full clock speeds) in Multi-display Modes”
on page 27
 “Aero Must be Enabled for Windowed SLI AFR Mode Under Vista” on page 27
 “SLI Connector Requirement on NVIDIA Quadro SLI Cards” on page 28
 “Applying Workstation Application Profiles” on page 28
 “1280x1024 @ 60 Hz not Available on BenQ FP241W Monitors” on page 28
 “Gigabyte GA-6BX Motherboard” on page 28
System Should not Enter Sleep/Hibernate Mode With SDI
Capture in Progress
SDI capture programs will become non-responsive upon resume from sleep or hibernate
modes.
This is not a typical use case, so power management tests should not be performed when
testing SDI.