User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Powering Up
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 CPU Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 SATA Configuration
- 4.5.13 APM Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 T1s Auth
- 4.5.16 Third-party UEFI driver configurations
- 4.5.17 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
A-7
ACTION PHASE POST CODE TYPE DESCRIPTION
PSP Boot
PSP Boot Loader
phase (Status Post
Codes)
0xA0 error Bootloader successfully entered C Main
0xA1 error Master initialized C2P / slave waited for master to init C2P
0xA2 error HMAC key successfully derived
0xA3 error Master got Boot Mode and sent boot mode to all slaves
0xA4 error SpiRom successfully initialized
0xA5 error BIOS Directory successfully read from SPI to SRAM
0xA6 error Early unlock check
0xA7 error Inline Aes key successfully derived
0xA8 error Inline-AES key programming is done
0xA9 error Inline-AES key wrapper derivation is done
0xAA error Bootloader successfully loaded HW IP configuration values
0xAB error Bootloader successfully programmed MBAT table
0xAC error Bootloader successfully loaded SMU FW
0xAD error Progress code is available
0xAE error User mode test Uapp completed successfully
0xAF error Bootloader loaded Agesa0 from SpiRom
0xB0 error AGESA phase has completed
0xB1 error RunPostDramTrainingTests() completed successfully
0xB2 error SMU FW Successfully loaded to SMU Secure DRAM
0xB3 error Sent all required boot time messages to SMU
0xB4 error Validated and ran Security Gasket binary
0xB5 error UMC Keys generated and programmed
0xB6 error Inline AES key wrapper stored in DRAM
0xB7 error Completed FW Validation step
0xB8 error Completed FW Validation step
0xB9 error BIOS copy from SPI to DRAM complete
0xBA error Completed FW Validation step
(continued on the next page)