User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 Super IO Configuration
- 3.3.7 Serial Console Redirection
- 3.3.8 SATA Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 NVMe Configuration
- 3.3.12 Onboard Device Configuration
- 3.3.13 APM Configuration
- 3.3.14 Watchdog Timer
- 3.3.15 EZ-Flash
- 3.3.16 LVDS Configuration
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
3-4
J6412T-IM-A
C states
[Disabled] Disables the CPU C states.
[Enabled] Enables the CPU C states.
Enhanced C-states
[Disabled] Disables enhanced C1E state.
[Enabled] Enables enhanced C1E state.
Power Limit 1 Override
[Disabled] Disables power limit 1 override.
[Enabled] Enables power limit 1 override.
The following item appears only when you set the previous item to [Enabled].
Power Limit 1
This item allows you to provide rapid protection when the package power
exceeds Power Limit 1. Use <+> and <-> to adjust the value.
Power Limit 2 Override
[Disabled] Disables power limit 2 override.
[Enabled] Enables power limit 2 override.
The following item appears only when you set the previous item to [Enabled].
Power Limit 2
This item allows you to provide rapid protection when the package power
exceeds Power Limit 2. Use <+> and <-> to adjust the value.
3.3.4 Graphics Configuration
RC6(Render Standby)
Allows you to enable to disable render standby support. RC6 should be enabled if
S0ix is enabled. Configuration options: [Disabled] [Enabled]
3.3.5 PCI Express Configuration
PCIE_x1 Slot
PCIE_x1 Slot
This item allows you to control the PCI Express root port.
Configuration options: [Disabled] [Enabled]
ASPM
This item allows you to control the Active State Power Management on
both NB (NorthBridge) side and SB (SouthBridge) side of the DMI Link.
Configuration options: [Disable] [L0s] [L1] [L0sL1] [Auto]