User Manual

3-11
Chapter 3: BIOS setup
3.3.15 EZ-Flash
Enter Ez-Flash mode
This item allows you to run EzFlash utility. When you press <Enter>, a confirmation
message appears. Use the left/right arrow key to select between [Yes] or [No],
then press <Enter> to confirm your choice.
3.3.16 LVDS Configuration
The items in this menu show the LVDS-related information that the BIOS
automatically detects.
IGD Flat Panel
Allows you to enable or disable IGD video output to the onboard LVDS.
Configuration options: [Auto] [Enabled] [Disabled]
EDID Data Source
Allows you to select the EDID data source. Configuration options: [Pre-defined]
[Flat Panel Display]
The following items appear only when you set the previous item to [Pre-
defined].
Pre-defined LVDS Panel Type
Allosw you to select the LVDS panel used by the internal graphics device by
selecting the appropriate setup item. Configuration options: [VBIOS Default]
[640x480] [800x600] [1024x768] [1280x1024] [1400x1050(RB) LVDS1]
[1400x1050 LVDS2] [1600x1200 LVDS] [1366x768 LVDS] [1680x1050]
[1920X1200] [1440x900 ;VDS] [1600X900 LVDS] [1024X768 LVDS2] [1280X800]
[1920X1080 LVDS] [2048X1536 LVDS]
Inverter Polarity
Allows you to select the inverter board polarity. Configuration options: [Inverted]
[Normal]
Channel Select
Allows you to select the channel. Configuration options: [Dual Channel] [Single
Channel]
Mode Select
Allows you to select the mode. Configuration options: [JEIDA] [VESA 6bit] [VESA
8bit] [VESA 10bit]