User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 Super IO Configuration
- 3.3.7 Serial Console Redirection
- 3.3.8 SATA Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 NVMe Configuration
- 3.3.12 Onboard Device Configuration
- 3.3.13 APM Configuration
- 3.3.14 Watchdog Timer
- 3.3.15 EZ-Flash
- 3.3.16 LVDS Configuration
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
2-11
Chapter 2: Motherboard information
2.6.2 Internal connectors
1. ATX power connector (4-pin ATX12V)
Correctly orient the ATX power supply plug into this connector and push
down rmly until the connector completely ts.
PIN 1
ATX12V
DC_PWR
DC_PWR
GND
GND
CAUTION: Do not forget to connect the fan cables to the fan headers.
Insufcient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the fan
headers!
2. Chassis Fan header (4-pin CHA_FAN)
Connect the fan cable to the fan header on the motherboard, ensuring that
the black wire of each cable matches the ground pin of the header.
CHA_FAN
O_CHAFAN_PWM_Q
O_CHAFANIN_R
12V
GND
PIN 1
Connector type
WAFER HD 4p, 2.54mm pitch, S/T