User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Motherboard information
- Chapter 3 BIOS setup
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 Super IO Configuration
- 3.3.7 Serial Console Redirection
- 3.3.8 SATA Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 NVMe Configuration
- 3.3.12 Onboard Device Configuration
- 3.3.13 APM Configuration
- 3.3.14 Watchdog Timer
- 3.3.15 EZ-Flash
- 3.3.16 LVDS Configuration
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
3-8
J6412T-IM-A
3.3.9 Network Stack Configuration
Network Stack
This item allows user to disable or enable the UEFI network stack. Configuration
options: [Disabled] [Enabled]
The following items appear only when you set the previous item to [Enabled].
Ipv4 PXE Support
This item allows user to disable or enable the Ipv4 PXE Boot support.
Configuration options: [Disabled] [Enabled]
Ipv6 PXE Support
This item allows user to disable or enable the Ipv6 PXE Boot support.
Configuration options: [Disabled] [Enabled]
3.3.10 USB Configuration
XHCI Hand-off
Allows you to enable or disable XHCI Hand-off. Set to [Disabled] to support
operating systems without a built-in USB 3.0 driver.
Configuration options: [Enabled] [Disabled]
USB Mass Storage Driver Support
Allows you to enable or disable USB mass storage driver support.
Configuration options: [Disabled] [Enabled]
U32G2_1/2/3
Allows you to enable or disable the USB port. Once set to [Disabled], any USB
devices plugged into the connector will not be detected by BIOS or OS.
Configuration options: [Disabled] [Enabled]
U2_4
Allows you to enable or disable the USB port. Once set to [Disabled], any USB
devices plugged into the connector will not be detected by BIOS or OS.
Configuration options: [Disabled] [Enabled]
USB1/2/3/4
Allows you to enable or disable the USB port. Once set to [Disabled], any USB
devices plugged into the connector will not be detected by BIOS or OS.
Configuration options: [Disabled] [Enabled]
3.3.11 NVMe Configuration
This page displays the NVMe controller and drive information.