User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 Super IO Configuration
- 3.3.7 Serial Console Redirection
- 3.3.8 SATA Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 NVMe Configuration
- 3.3.12 Onboard Device Configuration
- 3.3.13 APM Configuration
- 3.3.14 Watchdog Timer
- 3.3.15 EZ-Flash
- 3.3.16 LVDS Configuration
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
J6412T-IM-A
2-8
4. Chassis intrusion header (4-1 pin_CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The
chassis intrusion sensor or switch sends a low-level signal to this connector
when a chassis component is installed. The signal is then generated as a chassis
intrusion event.
PIN 1
3 4
3 4
CHASSIS
PIN 1
Chassis Intruder - Close Chassis Intruder - Open
3-4jumper closed
3-4jumper removed (Default)
Connector type
HEADER 4p, K2, 2.54mm pitch
5. LVDS Panel VCC Power Selection jumper (6-pin VCC_PWR_SEL)
12V5V
1
3V
(Default)
VCC_PWR_SEL
3
4
5
6
2
Connector type
HEADER 1 x 3p, 2.54mm pitch, S/T
Setting Pins
12V 1.4.5-6
5V 1.4.5-3
3V (Default) 1.4.5-2