Specifications

2-34
Chapter 2: BIOS information
PS/2 Keyboard and Mouse Support [Auto]
Select any of these settings when PS/2 keyboard and mouse are installed. These settings only apply
when Fast Boot is enabled.
[Auto] For a faster POST time, PS/2 devices will only be available when the system
boots up or rebooted when the PS/2 devices have not been reconnected or
changed. If you disconnect or change PS/2 devices before restarting the system,
PS/2 devices will not be available and BIOS setup program will not be accessible
via PS/2 devices.
[Full Initialization] For full system control, PS/2 devices will be available during POST at any
circumstances. This process will extend POST time.
[Disabled] For the fastest POST time, all PS/2 devices will not be available until your
computer enters the operating system.
Network Stack Driver Support [Disabled]
[Disabled] Select to skip the network stack driver from loading during POST.
[Enabled] Select to load the network stack driver during POST.
Next Boot after AC Power Loss [Normal Boot]
[NormalBoot] ReturnstonormalbootonthenextbootafterACpowerloss.
[Fast Boot] Accelerates the boot speed on the next boot after AC power loss.
2.8.2 Boot Logo Display [Auto]
[Auto] AdjustautomaticallyforWindows®requrement.
[FullScreen] Maximizethebootlogosize.
[Disabled] Hide the logo during POST.
POST Delay Time [3 sec]
This item appears only when you set Boot Logo Display to [Auto] or [Full Screen]. This item allows
you to select the desired additional POST waiting time to easily enter the BIOS setup. You can only
executethePOSTdelaytimeduringNormalBoot.Thevaluesrangefrom0to10seconds.
This feature will only work under normal boot.
Post Report [5 sec]
This item appears only when you set Boot Logo Display to [Disabled]. This item allows you to
selectadesiredpostreportwaitingtime.Congurationoptions:[1sec]~[10sec][UntilPressESC].
2.8.3 Bootup NumLock State [On]
[On] Setsthepower-onstateoftheNumLockto[On].
[O] Setsthepower-onstateoftheNumLockto[O].
2.8.4 Wait for ‘F1’ If Error [Enabled]
When this item is set to [Enabled], the system waits for the F1 key to be pressed when error occurs.
Configuration options: [Disabled] [Enabled]