User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 Super IO Configuration
- 3.3.7 Serial Console Configuration
- 3.3.8 SATA Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 NVMe Configuration
- 3.3.12 Onboard Devices Configuration
- 3.3.13 APM Configuration
- 3.3.14 EzFlash
- 3.3.14 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
3-11
Chapter 3: BIOS setup
USB5-10
Allows you to enable or disable USB port. Once set to [Disabled], any USB
devices plugged into the connector will not be detected by BIOS or OS.
Conguration options: [Disabled] [Enabled]
3.3.11 NVMe Configuration
The NVMe Conguration menu displays the NVMe controller and drive information
of the devices connected and allows you to congure NVMe device options
settings.
3.3.12 Onboard Devices Configuration
HD Audio
[Enabled] Enables the HD Audio Device.
[Disabled] Disables the HD Audio Device.
LAN1 I219V
[Enabled] Enables the Intel LAN1 controller.
[Disabled] Disables the controller.
LAN2 RTL8111H
[Enabled] Enables the Intel LAN2 controller.
[Disabled] Disables the controller.
mPCIE
PCIE Port
[Enabled] Enables the PCIE port.
[Disabled] Disables the PCIE port.
USB Port
[Enabled] Enables the USB port.
[Disabled] Disables the USB port.
3.3.13 APM Configuration
ErP Ready
Allows you to switch off some power at S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Conguration options: [Disabled] [Enabled]
Restore AC Power Loss
[S5 State] The system goes into off state after an AC power loss.
[S0 State] The system goes into on state after an AC power loss.