User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Start ASUS EzFlash
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 Platform Misc Configuration
- 3.3.5 CPU Configuration
- 3.3.6 System Agent (SA) Configuration
- 3.3.7 PCH Storage Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 ACPI Settings
- 3.3.10 LVDS Configuration
- 3.3.11 APM Configuration
- 3.3.12 NCT6116D Super IO Configuration
- 3.3.13 NCT6116D HW Monitor
- 3.3.14 Serial Port Console Redirection
- 3.3.15 USB Configuration
- 3.3.16 NVMe Configuration
- 3.3.17 HDD Secure Erase
- 3.3.18 Dynamic Digital IO
- 3.3.19 Network Stack Configuration
- 3.4 Security menu
- 3.5 Boot menu
- 3.6 Save & Exit menu
- 3.7 Event Logs
- BIOS setup
- Appendix
2-17
Chapter 2: Motherboard information
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
3. USB 2.0 connector (10-pin USB78)
This connector is for an USB 2.0 port. Connect the USB cable to this
connector. This USB connector complies with USB 2.0 specication that
supports up to 480 Mbps connection speed.
H310I-IM-B USB2.0 connector
USB78
PIN 1
USB+5V
USB_P7-
USB_P7+
GND
NC
USB+5V
USB_P8-
USB_P8+
GND
4. General purpose input/output connector (GPIO_CON)
This connector is for a general purpose input/output module which allows you
to customize the digital signal input/output.
H310I-IM-B GPIO connector
+5VSB
GPIO7
GPIO5
GPIO3
GPIO1
GND
GPIO8
GPIO6
GPIO4
GPIO2
GPIO_CON
PIN 1
Connector type
Header 2x5p, K9, 2.54mm pitch
Connector type
WAFER HD 2x5p, 2.0mm pitch, S/T