User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 PCI Express Configuration
- 3.3.7 CSM Configuration
- 3.3.8 Supper IO Configuration
- 3.3.9 Serial Console Redirection
- 3.3.10 SATA Configuration
- 3.3.11 USB Configuration
- 3.3.12 Onboard Devices Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 APM Configuration
- 3.3.15 EZ-Flash
- 3.3.16 Watchdog Timer
- 3.3.17 Miscellaneous
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
H310I-IM-A R3.0
2-16
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
3. USB 2.0 connectors (10-pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB cable to these
connectors. These USB connectors comply with USB 2.0 specication that
supports up to 480 Mbps connection speed.
USB78
USB+5V
USB_P7-
USB_P7+
GND
NC
USB+5V
USB_P8-
USB_P8+
GND
PIN 1
A
USB78
USB+5V
USB_P5-
USB_P5+
GND
NC
USB+5V
USB_P6-
USB_P6+
GND
PIN 1
B
A
B
4. General purpose input/output connector (GPIO_CON)
This connector is for a general purpose input/output module which allows you
to customize the digital signal input/output.
GPIO1
GPIO3
GPIO5
GPIO7
+5VSB
GPIO2
GPIO4
GPIO6
GPIO8
GND
GPIO_CON
PIN 1