User’s Manual

3-17
Chapter 3: BIOS setup
Critical Temp Tolerance [xx]
Input tolerance of critical temperature. The values range from 0~7.
The following item appears only when you set Fan Control Mode to [Manual
Mode].
PWM/DC Voltage Output [255]
Sets the voltage allocated for Fan Control. Input value range: [0~255]
The following item appears only when you set Fan Control Mode to [Thermal
Cruise Mode].
Temperature source [SYSTIN]
Target Temperature [xx]
Input fan control target temperature. The values range from 0~127.
Tolerance of Temperature [xx]
Input tolerance of target temperature. The values range from 0~7.
Fan Out Start-up Value [xx]
Input fan out start-up value. The values range from 0~255.
Fan Stop Duty [Down to 0]
This item allows you to set the temperature for CPU Fan when CPU temperature
is out of the target temperature. Conguration elds: [Down to 0] [To Fan out stop
Vaule]
Fan Out Stop Value [xx]
The Fan out value decreases to this value if the temperature stays below the lowest
temperature limit.
Fan Out Stop Time [xx]
Determines the amount of time it takes Fan out value to fall from the stop value to
zero. The values range from 0~255.
Critical Temperature [xx]
Determines the time that Fan Out takes to decrease its value by one step. The
values range from 0~255.
Fan Out Step Up Time [xx]
Determines the time that Fan Out takes to increase its value by one step. The
values range from 0~255.
Fan Out Step Down Time [xx]
Determines the time that Fan Out takes to decrease its value by one step. The units
are intervals of 0.1 second. The values range from 0~255.