User’s Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Platform Misc Configuration
- 3.3.2 CPU Configuration
- 3.3.3 System Agent (SA) Configuration
- 3.3.4 PCH Configuration
- 3.3.5 PCH Storage Configuration
- 3.3.7 LVDS Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 APM Configuration
- 3.3.10 USB Configuration
- 3.3.11 Network Stack Configuration
- 3.3.12 HDD/SSD SMART Information
- 3.4 Monitor menu
- 3.5 Boot menu
- 3.6 Tool menu
- 3.7 Exit menu
- BIOS setup
- Appendix
2-21
Chapter 2: Motherboard information
NOTE: The serial port cables are purchased separately.
15. Serial port connectors (10-pin COM3, COM4, COM5, COM6)
These connectors are for serial (COM) ports. Connect the serial port cables
to these connectors, then install the module to a slot opening at the back of
the system chassis.
H310I-IM-A R2.0 Serial port (COM) connectors
PIN 1
COM6、COM5、COM4、COM3
DCD#
TXD
GND
RTS#
Ring
RXD
DTR#
DSR#
CTS#
(NC)
16. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
Correctly orient the ATX power supply plugs into these connectors and push
down rmly until the connectors completely t.
H310I-IM-A R2.0 ATX power connectors
PIN 1
ATX12V
DC_IN
DC_IN
GND
GND
PIN 1
GND
+5 Volts
+5 Volts
+5 Volts
-5 Volts
GND
GND
GND
PSON#
GND
-12 Volts
+3 Volts
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
A
B
BA
EATXPWR