User’s Manual

3-9
Chapter 3: BIOS setup
SATA6G_1~2(Gray) [Enabled]
Allow you to enable/disable the SATA6G_1~2 port. Conguration options:
[Disabled] [Enabled]
SATA6G_1~2 Hot Plug [Disabled]
These items allow you to enable/disable SATA Hot Plug Support. Conguration
options: [Disabled] [Enabled]
M.2(SOCKET3) [Enabled]
Allow you to enable/disable the M.2(SOCKET3). Conguration options: [Disabled]
[Enabled]
3.3.6 PCH-FW Conguration
TPM Device Selection [Discrete TPM]
This item allows you to select the TPM device. Conguration options: [Discrete
TPM] [Firmware TPM]
ME Operation Mode [Normal]
When this item is set to [Temporary Disabled], the system will be reset
immediately. This option is for debug purpose. ME will return to normal mode once
the system is powered off. Conguration options: [Normal] [Temporary Disabled]
3.3.7 LVDS Conguration
All-in-One Chassis [None]
Select All-in-One Chassis if applicable. Conguration options: [None] [1920*1080
LVDS1] [1920*1080 LVDS2] [1920*1080 LVDS3] [1600*900 LVDS4]
EDID Data Source [Flat Panel Display]
Conguration options: [Pre-Dened] [Flat Panel Display]
The following item appears only when you set the EDID Data Source to [Pre-
Dened].
Pre-Dened LVDS Panel Type [Auto]
Select LVDS Panel Type. Conguration options: [Auto] [640x480] [800x600]
[1024x768] [1280x1024] [1400x1050(RB) LVDS1] [1400x1050 LVDS2] [1600x1200
LVDS] [1366x768 LVDS] [1680x1050] [1920x1200] [1440x900 LVDS] [1600x900
LVDS] [1024x768 LVDS2] [1280x800] [1920x1080 LVDS]
Inverter Polarity [Normal]
Allows you to select the inverter board polarity. Conguration options: [Normal]
[Inverted]
Channel Select [Dual Channel]
Conguration options: [Dual Channel] [Single Channel]