User Manual

3-26
H310A-EM-A
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data,
if the receiving buffers are full, a “stop” signal can be sent to stop the data
flow. Once the buffers are empty, a “start” signal can be sent to re-start the
flow. Hardware flow control uses two wires to send start/stop signals.
Conguration options: [None] [Hardware RTS/CTS]
VT-UTF8 Combo Key Support
Allows you to enable or disable VT-UTF8 Combination Key Support for ANSI/
VT100 terminals. Conguration options: [Disabled] [Enabled]
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal
data. Conguration options: [Disabled] [Enabled]
Resolution 100x31
Allows you to enable or disable extended terminal resolution.
Conguration options: [Disabled] [Enabled]
Putty KeyPad
Allows you to select FunctionKey and KeyPad on Putty.
Conguration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]
Serial Port for Out-of-Band Management / Windows Emergency Management
Services (EMS)
Console Redirection
Allows you enable or disable the console redirection feature.
Conguration options: [Enabled] [Disabled]
NOTE: The following item is accessible when you set Console Redirection to
[Enabled].
Out-of-Band Mgmt Port
Conguration options: [COM1] [COM2] [COM3] [COM4] [COM5] [COM6]
Terminal Type
Conguration options: [VT100] [VT100+] [VT-UTF8] [ANSI]
[VT100] ASCII char set.
[VT100+] Extends VT100 to support color, function keys, etc.
[VT-UTF8] Uses UTF8 encoding to map Unicode chars onto 1 or more bytes.
[ANSI] Extended ASCII char set.
Bits per second
Allows you to select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
Conguration options: [9600] [19200] [57600] [115200]