User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Ai Tweaker menu
- 3.3.1 CPU Power Enhancement
- 3.3.2 CPU Core Ratio
- 3.3.3 DRAM Odd Ratio Mode
- 3.3.4 DRAM Frequency
- 3.3.5 Power-saving & Performance Mode
- 3.3.6 DRAM Timing Control
- 3.3.7 DIGI+ VRM
- 3.3.8 Internal CPU Power Management
- 3.3.9 CPU Core/Cache Current Limit Max.
- 3.3.10 CPU Graphics Current Limit
- 3.3.11 Min. CPU Cache Ratio
- 3.3.12 Max. CPU Cache Ratio
- 3.3.13 Max. CPU Graphics Ratio
- 3.3.14 DRAM Voltage
- 3.3.15 DRAM REF Voltage Control
- 3.4 Advanced menu
- 3.4.1 Platform Misc Configuration
- 3.4.2 CPU Configuration
- 3.4.3 System Agent (SA) Configuration
- 3.4.4 PCH Configuration
- 3.4.5 PCH Storage Configuration
- 3.4.6 PCH-FW Configuration
- 3.4.7 Onboard Devices Configuration
- 3.4.8 APM Configuration
- 3.4.9 Serial Console Redirection
- 3.4.10 PCI Subsystem Settings
- 3.4.11 USB Configuration
- 3.4.12 Network Stack Configuration
- 3.4.13 HDD Secure Erase
- 3.4.14 HDD/SSD SMART Information
- 3.5 Monitor menu
- 3.6 Boot menu
- 3.7 Tool menu
- 3.8 Exit menu
- BIOS setup
- Appendix
2-13
Chapter 2: Motherboard information
3. Chassis Intrusion header (4-1 pin CHASSIS)
The Chassis Intrusion header is for a chassis-mounted intrusion detection
sensor or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is removed or
replaced. The signal is then generated as a chassis intrusion event.
+5VSB_MB
Chassis Signal
GND
CHASSIS
PIN 1