User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Platform Misc Configuration
- 3.3.2 CPU Configuration
- 3.3.3 System Agent (SA) Configuration
- 3.3.4 PCH Configuration
- 3.3.5 PCH Storage Configuration
- 3.3.6 PCH-FW Configuration
- 3.3.7 LVDS Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 APM Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 HDD/SSD SMART Information
- 3.3.12 USB Configuration
- 3.4 Monitor
- 3.5 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
H110T-CM-A
2-12
2.6 Connectors
2.6.1 Rear panel connectors
1 2 3 4 5 2 6 7
1. DC power connector. Insert the power adapter into this port.
• It can support both 19V and 12V DC input.
• The power adapter is purchased separately.
• Use the appropriate DC power adapter for the following scenarios.
- Use a 90W adapter when a 35W CPU is installed on the system.
- Use a 120W adapter when using your system with an LVDS panel.
- Use a high-rated adapter (above 90W) when a high-rated CPU (45W
or higher CPU) is in stalled on the system.
2. USB 3.0 (up to 5Gbps) ports. These 9-pin Universal Serial Bus (USB) ports
are for USB 3.0 devices.
3. HDMI
TM
port. This port is for a High-Denition Multimedia Interface (HDMI
TM
)
connector, and is HDCP compliant allowing playback of HD DVD, Blu-ray,
and other protected content.
4. DisplayPort. This port is for a DisplayPort-compatible device.
5. LAN (RJ-45) ports. These ports allow Gigabit connection to a Local Area
Network (LAN) through a network hub.
LAN port LED indications
LAN port
Speed
LED
Activity Link
LED
Activity/Link LED Speed LED
Status Description Status Description
Off No link OFF 10Mbps
connection
Orange Linked ORANGE 100Mbps
connection
Green (Blinking) Data activity GREEN 1Gbps connection
Green (Blinking
then steady)
Ready to wake
up from S5 mode