User Manual

3-8
H110T-CM-A R2.0
SATA Controller(s)
Enables or disables onboard the SATA device. Conguration options: [Disabled]
[Enabled]
The following items appear only when you set SATA Controller(s) to [Enabled].
Aggressive LPM Support
This item is designed for LPM (link power management) support with a better
energy saving conditions. When disabled, the hot plug function of SATA ports are
disabled. Conguration options: [Disabled] [Enabled]
Smart Self Test
This item allows you to enable or disable the SMART Self Test on all HDDs during
POST. Conguration options: [On] [Off]
SATA6G_1/2(Gray)
Allow you to enable/disable the SATA6G_1/2 port. Conguration options:
[Disabled] [Enabled]
SATA6G_1/2 Hot Plug
These items allow you to enable/disable SATA Hot Plug support. Conguration
options: [Disabled] [Enabled]
M.2(SATA)
Allow you to enable/disable the M.2 (SATA). Conguration options: [Disabled]
[Enabled]
3.3.6 PCH-FWConguration
TPM Device Selection
This item allows you to select the TPM device. Selects Firmware TPM to enable
PTT in SkuMgr and selects Discrete TPM to disable PTT in SkuMgr. Conguration
options: [Discrete TPM] [Firmware TPM]
ME Operation Mode
This item allows you to select the ME operation mode When set to [Temporary
Disabled], the system will reset immediately. This option is for Debugging purpose
(e.g Update ROM by Intel FPT utility), and ME Operation Mode will be normal in
the next bootup. Conguration options: [Normal] [Temporary Disabled]