User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Platform Misc Configuration
- 3.3.2 CPU Configuration
- 3.3.3 System Agent (SA) Configuration
- 3.3.4 PCH Configuration
- 3.3.5 PCH Storage Configuration
- 3.3.6 PCH-FW Configuration
- 3.3.7 LVDS Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 APM Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 HDD/SSD SMART Information
- 3.3.12 USB Configuration
- 3.4 Monitor
- 3.5 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
H110T-CM-A R2.0
2-16
NOTE: The serial port cables are purchased separately.
6. COM Port header (10-1 pin COM)
This header is for a serial (COM) port. Connect the serial port cable to this
header, then install the module to a slot opening at the back of the system
chassis.
COM
RXD1
DTR1#
DSR1#
CTS1#
DCD1#
TXD1
GND
RTS1#
RI1#
PIN 1
PIN 2
PIN 9
PIN 10
Connector type
Header 2x5p, K10, 2.54mm pitch
5. SATA Power connector (15-pin SATA_PWR)
This connector is for the SATA power cable. The power cable plug is
designed to t this connector in only one orientation. Find the proper
orientation and push down rmly until the connector completely ts.
PIN 1
SATA_PWRCON
+12V
+12V
+12V
GND
GND
GND
+5V
+5V
+5V
GND
GND
GND
+3V
+3V
+3V
IMPORTANT: The SATA power connector supports 1.5A current to the
maximum.