User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Platform Misc Configuration
- 3.3.2 CPU Configuration
- 3.3.3 System Agent (SA) Configuration
- 3.3.4 PCH Configuration
- 3.3.5 PCH Storage Configuration
- 3.3.6 PCH-FW Configuration
- 3.3.7 LVDS Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 APM Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 HDD/SSD SMART Information
- 3.3.12 USB Configuration
- 3.4 Monitor
- 3.5 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
H110T-CM-A R2.0
2-14
2.6.2 Internal connectors
1. ATX Power connector (2-pin ATX19V)
Correctly orient the ATX power supply plug into this connector and push
down rmly until the connector completely ts.
PIN 1
ATX19V
DC_JACK_INGND
CAUTION: Do not forget to connect the fan cables to the fan headers.
Insufcient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the fan
headers!
2. CPU and Chassis fan headers (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan headers on the motherboard, ensuring that
the black wire of each cable matches the ground pin of the header.
CPU_FAN
O_CHAFAN_PWM_Q
O_CHAFANIN1_R
CHAFANPWR
GND
O_CPUFAN_PWM_Q
O_CPUFANIN_R
+12V
GND
B
CHA_FAN
A
A
PIN 1 PIN 1
B
Connector type
WAFER HD 4p, 2.54mm pitch, S/T
NOTE: This connector supports 12V and 19V by models. Refer to the
specication sheet of the model for details.