User's Manual

ASUS H110I-PLUS
1-3
USB 3.0 connector (20-1 pin USB3_12)
This connector allows you to connect a USB 3.0 module for additional USB 3.0
front or rear panel ports. With an installed USB 3.0 module, you can enjoy all
the benets of USB 3.0 including faster data transfer speeds of up to 5 Gbps,
faster charging time for USB-chargeable devices, optimized power efciency, and
backward compatibility with USB 2.0.
Intel
®
H110 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
PCI Express 3.0/2.0 x16 slot
This motherboard has one PCI Express 3.0/2.0 x16 slot that supports PCI Express
3.0/2.0 x16 graphic cards complying with the PCI Express specications.
IRQ assignments for this motherboard
A B C D E F G H
PCIEx16 shared – – – – – – –
Realtek 8111H LAN
Controller
– shared – – – – – –
USB 3.0 Controller shared – – – – – – –
SATA Controller shared – – – – – – –
HD Audio Controller shared – – – – – – –
When using PCI cards on shared slots, ensure that the drivers support “Share IRQ” or
that the cards do not need IRQ assignments. Otherwise, conicts will arise between the
two PCI groups, making the system unstable and the card inoperable.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this connector.
The chassis intrusion sensor or switch sends a high-level signal to this connector
when a chassis component is removed or replaced. The signal is then generated
as a chassis intrusion event.
By default, the pins labeled “Intruder” are shorted with a jumper cap. Remove the
jumper caps only when you intend to use the chassis intrusion detection feature.