Specifications

1-20
Chapter 1: Product introduction
Chapter 1
DO NOT connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB 2.0 module is purchased separately.
8. USB 2.0 connectors (10-1 pin USB910, USB1112, USB1314)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specication that supports up to
48 Mb/s connection speed.
H97-PRO
H97-PRO USB2.0 connectors
USB+5V USB_P11- USB_P11+ GND NC
USB+5V
USB_P12-
USB_P12+
GND
USB1112
PIN 1
USB+5V USB_P9- USB_P9+ GND NC
USB+5V
USB_P10-
USB_P10+
GND
USB910
PIN 1
USB+5V USB_P13- USB_P13+ GND NC
USB+5V
USB_P14-
USB_P14+
GND
USB1314
PIN 1
9. Intel
®
Serial ATA 6 Gb/s connectors (7-pin SATA6G_56, SATAEXPRESS)
These connectors connect to Serial ATA 6 Gb/s hard disk drives via Serial ATA 6 Gb/s
signal cables.
• The M.2 Socket 3 and SATAEXPRESS connector shares the same bandwidth. When
you use both connectors, the system automatically detects the devices connected
to these connectors and set a higher priority to M.2 Socket 3 than SATAEXPRESS
interface. Refer to section 3.6.3 PCH Storage Configuration of this user guide for
more details.
• The SATAEXPRESS connector can support one SATA Express device or two SATA
devices.
H97-PRO
H97-PRO Intel
®
SATA 6 Gb/s connectors
SATA6G_5
SATAEXPRESS
SATA6G_6
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXN2
RSATA_RXP2
GND
Floating
Device_Reset
GND
Detection