Manual
GigaX3124 Layer3 Switch CLI Command Reference
268
it is necessary to establish a direct link between routers. The
neighbor command allows the network administrator to specify
a router as a RIP neighbor. The no neighbor A.B.C.D command
will disable the RIP neighbor.
Examples ASUS(cong-router)# neighbor 10.1.1.1
24.11 network (A.B.C.D/M| IFNAME)
Syntax network (A.B.C.D/M| IFNAME)
Parameters A.B.C.D/M IP address/netmask
IFNAME Interface name
Command Mode Cong-router mode
No/clear no network (A.B.C.D/M| IFNAME)
Show show ip rip status
Default
Description Set the RIP enable interface by network or L3 interface name.
The interfaces which have addresses matching with network or
name are enabled.
Examples ASUS(cong-router)# network 10.1.1.0/24
ASUS(cong-router)# network vlan10
24.12 passive-interface (IFNAME|default)
Syntax passive-interface (IFNAME|default)
Parameters IFNAME Interface name
default default for all interfaces
Command Mode Cong-router mode
No/clear no passive-interface (IFNAME|default)
Show show ip rip status
Default Not enable
Description This command sets the specied interface to passive mode.
On passive mode interface, all receiving packets are processed
as normal and RIP daemon does not send either multicast or
unicast RIP packets except to RIP neighbors specied with