Manual

GigaX3124 Layer3 Switch CLI Command Reference
2
• Cong-vlan
• Mac access-list extended
• IP standard access-list
• IP extended access-list
• Policy-map conguration
• Policy-map-class conguration
• Cong-router
When you start a session on the switch, you begin in user mode, often called
user EXEC mode, which has only a limited subset of the commands. To
access all commands and modes, you must rst enter privileged EXEC mode.
From privileged mode, you can enter any EXEC command or enter global
conguration mode. Most of the EXEC commands are one-time commands,
such as show commands, which show the current conguration status, and no
commands, which clear counters or interfaces.
You can use the Cong-vlan (virtual LAN) and the various conguration
modes to make changes to the running conguration. To access the various
conguration modes, you must start at global conguration mode. From global
conguration mode, you can enter interface and line conguration modes.
Table 1-1 describes how to access each mode, the prompt you see in that mode,
and how to exit the mode. The examples in the table use the host name ASUS.
Table 1-1: Command Modes Summary
C o m m a n d
mode
Access method Prompt Exit or Access Next
Mode.
User EXEC This is the rst level
of access.(For the
switch) Change termi-
nal settings, perform
basic tasks, and list
system information.
ASUS> Exit to enter the EXIT
command. To enter privi-
leged EXEC mode, enter
the enable command.
Privileged
EXEC
From user EXEC
mode, enter the
enable command.
ASUS# To exit to user EXEC mode,
enter the disable command.
To enter global conguration
mode, enter the congure
terminal command.