Manual

GigaX3124 Layer3 Switch CLI Command Reference
209
No/clear
Show show spanning-tree interface [IFNAME]
Default Not enable bpdu-guard
Description If bpdu-guard is enabled and the system receives any STP bpdu
from the interface, the inerface will be blocked.
Example ASUS(cong-if)# spanning-tree bpdu-guard enable
17.9 spanning-tree cost <1-200000000>
Syntax spanning-tree cost <1-200000000>
Parameters <1-200000000> Path cost value
Command Mode Interface conguration mode
No/clear no spanning-tree cost
Show show spanning-tree interface [IFNAME]
Default According link speed and status auto to set.
Description Use the spanning-tree cost conguration command on the
switch stack or standalone switch to set the spanning-tree path
cost.
Example ASUS(cong-if)# spanning-tree cost 128
17.10 spanning-tree edge-port (auto| disable|
enable)
Syntax spanning-tree edge-port (auto | disable| enable)
Parameters edge-port the interface is attached to a LAN segment that
is at the end of a bridged LAN or to an end node
auto Automatically determine by receiving BPDU
disable Disable edge-port on the interface
enable Enable edge-port on the interface
Command Mode Interface conguration mode
No/clear no spanning-tree edge-port
Show show spanning-tree interface [IFNAME]