Owner's manual
84
Chapter 5 - Command Line Interface
5.3.13.3 show storm-control
Use the show storm-control conguration command on the switch to show
the limit rate of the port’s total bandwidth used by broadcast/dlf/multicast.
CLI Syntax
: show storm-control (broadcast | dlf | multicast)
Example
: ASUS# show storm-control broadcast
5.3.14 Dynamic Addresses
5.3.14.1 clear dynamic mac-address
Use the command on the switch to clear dynamic L2 MAC addresses in
the database.
CLI Syntax
: clear mac-address-table dynamic mac MACADDR
Example
: (cong)# clear mac-address-table dynamic mac
0000.1111.2222
5.3.14.2 aging time
Use the mac-address-table aging-time configuration command on the
switch stack or on a standalone switch to set the length of time that a
dynamic entry remains in the MAC address table after the entry is used or
updated.
The real aging-time is the triple of the command input radix number.
CLI Syntax
: mac-address-table aging-time <10-1000000>
Example
: (cong)# mac-address-table aging-time 100
This example shows how to congure the mac-address-table aging-time to
300 seconds.
5.3.14.3 no aging time
Reset the age timer of the mac-address-table.
CLI Syntax
: no mac-address-table aging-time
Example
: (cong)# no mac-address-table aging-time