Owner's manual
70
Chapter 5 - Command Line Interface
Table 7: Boot ROM Commands
Command Parameters Usage Notes
baudrate Baud Rate 9600
19200
38400
57600
115200
You have to set up the
terminal emulator with the
same baud rate to make
the work
ethaddr none none get MAC address
gatewayip Ip address xxx.xxx.xxx.xxx get gateway IP address
go none none boot rmware IP address
? or help none none print online help
ipaddr IP address xxx.xxx.xxx.xxx set tftp client IP address
xload none none load binary le over serial
line (X modem)
ping host xxx.xxx.xxx.xxx send ICMP ECHO_
REQUEST to network host
pwd none none reset switch password
serverip IP address xxx.xxx.xxx.xxx set tftp server IP address
slot slot 1, 2, auto select boot slot to boot
tftpboot lename Example: rmware.img load image via network using
TFTP protocol
version none none show Boot ROM version
Figure 75. Boot ROM command mode
5.1.2 Boot ROM commands
The followings are two types of boot ROM commands,
• “command” : The current settings will be displayed.
• “command” with new setting
The current setting will be replaced by specied new setting.