Manual

GigaX2024B/M L2 Managed Switch CLI Manual
200
Command Mode
Interface mode
No/clear
no speed
Show
show l2_interface IFNAME
Default
None or depends on ODM customer
Description
Use the speed conguration command on the switch stack or
standalone switch to set speed status of the port.
Examples
ASUS(cong-if)#speed 100
15.15 shutdown
Syntax
shutdown
Parameters
Command Mode
Interface conguration
No/clear
no shutdown
Show
show running-cong
Default
Description
The shutdown command for a port causes it to stop forwarding.
You can enable the port with the no shutdown command.
The no shutdown command has no effect if the port is a
static-access port assigned to a VLAN that has been deleted,
suspended, or shut down. The port must rst be a member of an
active VLAN before it can be re-enabled.
Only one management VLAN interface can be active at a time.
The remaining VLANs are shut down.
In the show running-cong command, the active management
VLAN interface is the one without the shutdown command
displayed.
Examples
ASUS(cong-if)# shutdown
15.16 default-priority<0-7>
Syntax
default-priority <0-7>
Parameters
<0-7> Cos priority
Command Mode
Interface mode