Manual

52
Chapter 6 - Troubleshooting
ASUS GigaX 1024i+
1. Open the command prompt window.
2. Change to the directory where the auto-cong le is located.
3. Use the command “
ftp <IP Address>
” to connect to the FTP server,
ex: “
ftp 192.192.1.100
”.
4. Type the system’s user name.
5. Type the system’s password.
6. Use the command “
put <File Name>
” to upload auto-config file.
“
#autocong
” must be included at the header of the le, and the le
name of the auto-config file must be “
config.bat
”, ex: “
put config.
bat
”.
6.3.3 Backup system congurations by FTP
Make sure your PC and the switch
are in the same VLAN before you
use ftp function as well as the
other remote management tools.
The switch VLAN is shown in the
System-->IP setup
” page of the
WEB GUI or use “
net interface
show
” to display the VID by CLI.
1. Open the command prompt
window.
2. Change to the directory that the system configurations file will be
located.
3. Use the command “
ftp <IP Address>
” to connect to the switch IP
address as your FTP server IP, ex: “
ftp 192.192.1.100
”.
4. Type the system’s user name.
5. Type the system’s password.
6. The default le name of the system conguration le is “
backup
”. You
must use this le name to backup the system conguration. The le
can be renamed after downloading.
Figure 53. Backup system
congurations by FTP