Manual
49
Chapter 6 - Troubleshooting
ASUS GigaX 1024i+
6.2 Simple xes
Table 8: Problems & suggested actions
Problem Suggested Action
LEDs
SYSTEM LED does
not light up after the
switch is turned on.
Verify if the power cord is securely connected to the switch
and a wall socket/power strip.
Gigabit Ethernet Link
LED does not illumi-
nate after an Ethernet
cable is attached.
1. Verify if the Ethernet cable is securely connected to your
LAN switch/hub/PC and to the switch. Make sure the PC
and/or hub/switch is turned on.
2. Verify if your cable is sufcient for your network require-
ments. A 1000 Mbps network (1000BaseTx) should use
cables labeled Cat 5. 10Mbit/sec cables may tolerate lower
quality cables.
Network Access
PC cannot access
another host in the
same network
1. Check the Ethernet cabling is good and the LED is green.
2. If the port LED is amber, check if this port is disabled. You
may experience a disconnected network in a short period
(around 1 minute) if you just turned on the STP.
PCs cannot display web
conguration pages.
1. The switch is powered up and the connecting port is
enabled. The factory default IP for the switch is 192.168.1.1.
2. Verify your network setup in your PC for this in-
formation. If your PC does not have a valid route
to access the switch, change the switch IP to an
appropriate IP that your PC can access.
3. Ping “switch IP” from the PC, if it still fails, repeat step 2.