Manual

42
Chapter 4 - Conguration Management
ASUS GigaX 1024i+
When you enable the Cable Diagnosis on a port, the connection of
this port will be disconnected during the diagnosis.
4.8 Statistics Chart
The
Statistics Chart
pages provide network ow in different charts. You
can specify the period/time to refresh the chart. You can monitor the
network trafc amount in different graphic chart by these pages. Most MIB-
II counters are displayed in these charts.
Click <
Auto Refresh
> to set the period for retrieving new data from the
switch. You can differentiate the statistics or ports by selecting
Color
.
Finally, click <
Draw
> to let the browser to draw the graphic chart. Each
new Draw will reset the statistics.
4.7 Cable Diagnosis
T h e m a j o r f u n c t i o n o f
C a b l e
Diagnosis
is to detect cable fault
(open or short) an d repo r t the
estimated fault location. Moreover,
Cable Diagnosis can also detect
PHY type (10M, 100M or 1000M)
as well as estimated cable length
of a normal cable. Cable length
estimation only supports Giga speed
mode.
Just select a port number and click <
Go
>. Test results shall be displayed
accordingly.
Figure 45. Cable Diagnosis
Figure 46. Trafc Comparison
4.8.1 Trafc Comparison
This page shows one statistical item
for all the ports in one graphic chart.
Specify the statistics item to display
and click <
Draw
>. The browser will
show you the updated data and
refresh the graphic periodically.