Manual

24
Chapter 4 - Conguration Management
ASUS GigaX 1024i+
4.3.6 Bandwidth Control
B a n d w i d t h co n t r o l li m i t s t h e
tr a n s mi ss io n ra te of se le c te d
frames. The switch supports this
on a per port basis by setting the
conguration in the following elds:
Ingress bandwidth control
•
Port
: Select the port to congure.
•
Control
: Disable/enable the
ingress bandwidth control.
•
Mode
:
•
Bcast
: Limit the broadcast packets.
•
Bcast, Mcast
: Limit the broadcast and multicast packets.
•
Bcast, Mcast, Dlf
: Limit the broadcast packets, multicast
packets and unicast packets because of destination address
lookup failure.
•
All
: Limit all types of packets.
•
Limit Rate
: The threshold to limit the total number of the selected
type of packet. For example, if broadcast/multicast is enabled, the
trafc amount of each type will not exceed the limit value. The valid
value is from 70 to 250000(Kbps).
Egress bandwidth control
•
Port
: Select the port to congure.
•
Bandwidth Control
: Disable/enable the bandwidth control.
•
Limit Rate
: Maximum egress transmission rate. The valid value is from
70 to 250000(Kbps).
Click <
OK
> to send the settings to the switch via the HTTP server. Click
<
Reload
> to refresh the settings. To permanently save the conguration,
go to the
Save Conguration
page, then click <
Save
>.
Figure 22. Bandwidth Control