Manual
6
Chapter 2 - Quick Start
ASUS GigaX 1024i+
2 Quick Start
This section provides the basic instructions to set up the GigaX 1024i+
environment. Refer also to the GigaX 1024i Installation Guide.
• Part 1 shows you how to install the GigaX 1024i+ on a at surface
or on a rack.
• Part 2 provides instructions to set up the hardware.
• Part 3 shows you how to congure the basic settings on the GigaX
1024i+.
Before starting, obtain the following information from your network
administrator:
• IP address for the switch
• Default gateway for the network
• Network mask for this network
2.1 Part 1: Installing the switch
The switch can be installed either on a at surface or on a rack.
2.1.1 Installing on a at surface
The switch should be installed on a flat surface which can support the
weight of the switches and their accessories. Attach four rubber pads on
the four indented circles located at the bottom of the switch. See illustration
below.
1
2
3
4
Indented circles 1, 2, 3, & 4.
Attach rubber pads here.