User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis cover
- 2.2 Air ducts
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 Storage devices
- 2.6 Expansion slots
- 2.6.1 Installing an expansion card to the front PCIe riser card bracket (on select models)
- 2.6.2 Installing an ASUS PIKE II card
- 2.6.3 Installing an HBA/RAID card
- 2.6.4 Installing an expansion card to the rear left PCIe expansion card bracket (on select models)
- 2.6.5 Installing an expansion card to the rear right PCIe expansion card bracket (on select models)
- 2.6.6 Installing an OCP 3.0 card to the rear right OCP 3.0 socket board (on select models)
- 2.6.7 (optional) Installing the PFR module
- 2.7 Cable connections
- 2.8 Removable/optional components
- 2.9 Installing GPU cards
- 2.10 Installing Optional Kits
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Serial Port Console Redirection
- 3.5.7 CPU Configuration
- 3.5.8 PCI Subsystem Settings
- 3.5.9 USB Configuration
- 3.5.10 Network Stack Configuration
- 3.5.11 CSM Configuration
- 3.5.12 NVMe Configuration
- 3.5.13 SATA Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Tls Auth Configuration
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Save & Exit menu
- 3.11 Event Logs menu
- 3.12 Server Mgmt menu
- Chapter 4: Driver Installation
- Appendix
3-25
ASUS ESC8000A-E11
TrdrdScL Ctrl [Auto]
Specifies TrdrdScL.
Configuration options: [Auto] [Manual]
The following item appears only when TrdrdScL Ctrl is set to [Manual].
TrdrdScL [3]
Specifies the CAS to CAS Delay Time, same bank group. Valid values
Fh-1h.
TwrwrScL Ctrl [Auto]
Specifies TwrwrScL.
Configuration options: [Auto] [Manual]
The following item appears only when TwrwrScL Ctrl is set to [Manual].
TwrwrScL [3]
Specifies the CAS to CAS Delay Time, same bank group. Valid values
3Fh-1h.
Trfc Ctrl [Auto]
Specifies Trfc.
Configuration options: [Auto] [Manual]
The following item appears only when Trfc Ctrl is set to [Manual].
Trfc [138]
Specifies the Refresh Recovery Delay Time (tRFC1). Valid values
3DEh-3Ch.
Trfc2 Ctrl [Auto]
Specifies Trfc2.
Configuration options: [Auto] [Manual]
The following item appears only when Trfc2 Ctrl is set to [Manual].
Trfc2 [C0]
Specifies the Refresh Recovery Delay Time (tRFC2). Valid values
3DEh-3Ch.
Trfc4 Ctrl [Auto]
Specifies Trfc4.
Configuration options: [Auto] [Manual]
The following item appears only when Trfc4 Ctrl is set to [Manual].
Trfc4 [84]
Specifies the Refresh Recovery Delay Time (tRFC4). Valid values
3DEh-3Ch.
Tcwl [Auto]
Specifies the CAS Write Latency.
Configuration options: [Auto] [9 Clk] [0Ah Clk] [0Bh Clk] [0Ch Clk] [0Eh
Clk] [10h Clk] [12h Clk] [14h Clk]