User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Ai Tweaker
- 4.5 Performance Tuning menu
- 4.6 Advanced menu
- 4.6.1 Trusted Computing
- 4.6.2 ACPI Settings
- 4.6.3 Smart Settings
- 4.6.4 Super IO Configuration
- 4.6.5 Serial Port Console Redirection
- 4.6.6 Onboard LAN Configuration
- 4.6.7 APM
- 4.6.8 PCI Subsystem Settings
- 4.6.9 USB Configuration
- 4.6.10 CSM Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 Network Stack Configuration
- 4.6.13 iSCSI Configuration
- 4.7 Platform Configuration menu
- 4.8 Socket Configuration menu
- 4.9 Event Logs menu
- 4.10 Server Mgmt menu
- 4.11 Security menu
- 4.12 Boot menu
- 4.13 Tool menu
- 4.14 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-40
GPU card power cable
6-pin GPU card
power connector
7. Attach the other end of the power cable (6-pin power connector) to an available 6-pin
power connector on the middle of the server system (A), align and insert the golden
fingers of the GPU card into the PCIE slot on the PCIE SKU board (B), then secure the
GPU card with the two (2) screws that you removed earlier in step 1 (C).
8. Repeat steps 1-7 if you need to install additional GPU cards.
2.9 Rail Kit Options
This server system supports the rail kit options listed below. For more information on rail kit
installation, refer to corresponding documentation on the ASUS support site or on the official
product site for this server system.
• We strongly recommend that at least two able-bodied persons perform the installation
of the rail kit.
• We recommend the use of an appropriate lifting tool or device, if necessary.
• 1m half extension ball bearing rail kit
• 1.2m half extension ball bearing rail kit