User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Ai Tweaker
- 4.5 Performance Tuning menu
- 4.6 Advanced menu
- 4.6.1 Trusted Computing
- 4.6.2 ACPI Settings
- 4.6.3 Smart Settings
- 4.6.4 Super IO Configuration
- 4.6.5 Serial Port Console Redirection
- 4.6.6 Onboard LAN Configuration
- 4.6.7 APM
- 4.6.8 PCI Subsystem Settings
- 4.6.9 USB Configuration
- 4.6.10 CSM Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 Network Stack Configuration
- 4.6.13 iSCSI Configuration
- 4.7 Platform Configuration menu
- 4.8 Socket Configuration menu
- 4.9 Event Logs menu
- 4.10 Server Mgmt menu
- 4.11 Security menu
- 4.12 Boot menu
- 4.13 Tool menu
- 4.14 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
2-23
ASUS ESC8000 G4 Series
2.5.2 Installing an ASUS PIKE II card
ASUS PIKE II
card bracket
1. Remove the two (2) screws on the ASUS PIKE II card bracket (A), then remove the
ASUS PIKE II card bracket (B) from the chassis.
4. Align and install the Cache Vault Flash
Module to the connector on the ASUS
PIKE II card (A), then secure the Cache
Vault Flash Module to the screw washers
with the bundled screws (B).
2. Prepare the ASUS PIKE II card.
3. Align the two (2) screw washers to the
two screw holes on the ASUS PIKE II
card (A), then secure the bundled screws
to the screw washers from the bottom of
the ASUS PIKE II card (B).