User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Ai Tweaker
- 4.5 Performance Tuning menu
- 4.6 Advanced menu
- 4.6.1 Trusted Computing
- 4.6.2 ACPI Settings
- 4.6.3 Smart Settings
- 4.6.4 Super IO Configuration
- 4.6.5 Serial Port Console Redirection
- 4.6.6 Onboard LAN Configuration
- 4.6.7 APM
- 4.6.8 PCI Subsystem Settings
- 4.6.9 USB Configuration
- 4.6.10 CSM Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 Network Stack Configuration
- 4.6.13 iSCSI Configuration
- 4.7 Platform Configuration menu
- 4.8 Socket Configuration menu
- 4.9 Event Logs menu
- 4.10 Server Mgmt menu
- 4.11 Security menu
- 4.12 Boot menu
- 4.13 Tool menu
- 4.14 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-18
2.4 Storage devices
The system supports hot-swap 2.5-inch SATA/SAS/NVME storage devices. The storage
device installed in the storage bay connects to the motherboard SATA/SAS/NVME ports via
the SATA/SAS/NVME backplane.
2.4.1 Installing the 2.5-inch SATA/SAS/NVME storage
device
NVME storage devices are only supported on the top 2 (two) storage bays. If you wish to
install an NVME storage device, ensure to install them to the 2 (two) top storage bays.
To install a 2.5-inch storage device:
1. Press the spring lock.
2. Pull the tray lever outwards to remove
the storage device tray.