User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Ai Tweaker
- 4.5 Performance Tuning menu
- 4.6 Advanced menu
- 4.6.1 Trusted Computing
- 4.6.2 ACPI Settings
- 4.6.3 Smart Settings
- 4.6.4 Super IO Configuration
- 4.6.5 Serial Port Console Redirection
- 4.6.6 Onboard LAN Configuration
- 4.6.7 APM
- 4.6.8 PCI Subsystem Settings
- 4.6.9 USB Configuration
- 4.6.10 CSM Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 Network Stack Configuration
- 4.6.13 iSCSI Configuration
- 4.7 Platform Configuration menu
- 4.8 Socket Configuration menu
- 4.9 Event Logs menu
- 4.10 Server Mgmt menu
- 4.11 Security menu
- 4.12 Boot menu
- 4.13 Tool menu
- 4.14 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
4-29
ASUS ESC8000 G4 Series
4.7.1 PCH Configuration
PCH Devices
DeepSx Power Policies [Disabled]
Allows you to configure the DeepSx Mode configuration.
Configuration options: [Disabled] [Enabled in S5] [Enabled in S4 and S5]
GP27 Wake From DeepSx [Disabled]
Allows you to enable or disable GP27 Wake From DeepSx.
Configuration options: [Disabled] [Enabled]
PCI Express Configuration
PCI-E ASPM Support (Global) [L1 Only]
Allows you to select ASPM support for all downstream devices.
Configuration options: [Per individual port] [L1 Only]
PCH DMI ASPM [Platform-POR]
Allows you to configure the PCH DMI ASPM.
Configuration options: [Platform-POR] [ASPM L1] [Disabled]
PCH SATA Configuration
SATA Controller [Enabled]
Allows you to enable or disable the SATA Controller.
Configuration options: [Disabled] [Enabled]
Configure sSATA as [AHCI]
Allows you to identify the SATA port connected to Solid State Drive or Hard Disk Drive.
Configuration options: [IDE] [AHCI] [RAID]
Support Aggressive Link Power Management [Enabled]
Allows you to enable or disable the Support Aggressive Link Power (SALP)
Management.
Configuration options: [Disabled] [Enabled]