User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis cover
- 2.2 Air ducts
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 Storage devices
- 2.6 Expansion slots
- 2.6.1 Installing an expansion card to the front PCIe expansion card bracket (on select models)
- 2.6.2 Installing an ASUS PIKE II or RAID card
- 2.6.3 Installing the Cache Vault Power Module
- 2.6.4 Installing an expansion card to the rear PCIe expansion card slots (on select models)
- 2.6.5 Installing an OCP 3.0 card to the rear OCP 3.0 socket board (on select models)
- 2.6.6 (optional) Installing the PFR module
- 2.7 Cable connections
- 2.8 Removable/optional components
- 2.9 Installing optional kits
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Advanced menu
- 3.4.1 Trusted Computing
- 3.4.2 ACPI Settings
- 3.4.3 Redfish Host Interface Settings
- 3.4.4 Onboard LAN Configuration
- 3.4.5 Serial Port Console Redirection
- 3.4.6 SIO Configuration
- 3.4.7 PCI Subsystem Settings
- 3.4.8 USB Configuration
- 3.4.9 Network Stack Configuration
- 3.4.10 NVMe Configuration
- 3.4.11 APM Configuration
- 3.4.12 T1s Auth Configuration
- 3.4.13 Third-party UEFI driver configurations
- 3.5 Platform Configuration menu
- 3.6 Socket Configuration menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Save & Exit menu
- Chapter 4: Driver Installation
- Appendix
3-33
ASUS ESC8000-E11
3.6.2 Common RefCode Configuration
Virtual Numa [Disabled]
Allows you to enable or disable virtual non-uniform memory access (NUMA).
Configuration options: [Disabled] [Enabled]
UMA-Based Clustering [Quadrant (4-Clusters)]
Allows you to set the UMA-based clustering mode.
Configuration options: [Hemisphere (2-clusters)] [Quadrant (4-clusters)]
3.6.3 Uncore Configuration
Uncore General Configuration
Allows you to configure Uncore General settings.
Uncore Per Socket Configuration
Allows you to configure Uncore Per Socket settings.