User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Advanced menu
- 4.5.1 CPU Configuration
- 4.5.2 Platform Misc Configuration
- 4.5.3 System Agent (SA) Configuration
- 4.5.4 PCH Configuration
- 4.5.5 PCH Storage Configuration
- 4.5.6 Serial Port Console Redirection
- 4.5.7 CPU Storage Configuration
- 4.5.8 Onboard Devices Configuration
- 4.5.9 APM Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 HDD/SSD SMART Information
- 4.5.12 USB Configuration
- 4.5.13 Thunderbolt(TM) Configuration
- 4.5.14 PCH-FW Configuration
- 4.6 Boot menu
- 4.7 Tool menu
- 4.8 Exit menu
- 4.9 Server Mgmt menu
- 4.10 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-16
Installing 2.5-inch HDD/SSD
To install a 2.5-inch HDD/SSD:
1. Remove the side cover of the chassis. Refer to the
Removing the side cover
section
for more information.
2. Prepare the 2.5-inch HDD/SDD and the bundled set of screws.
3. Lay the system on its side on a at and stable surface.
4. Locate the HDD cage lock, press it up (A), then swing the HDD cage outwards (B).
5. Align and insert the 2.5-inch HDD/SSD into the drive bay as shown. Push it all the
way until its screw holes align with the holes on the drive bay.
HDD cage lock
HDD cage
Matching screw holes
2.5-inch HDD/SSD