User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Advanced menu
- 4.5.1 CPU Configuration
- 4.5.2 Platform Misc Configuration
- 4.5.3 System Agent (SA) Configuration
- 4.5.4 PCH Configuration
- 4.5.5 PCH Storage Configuration
- 4.5.6 Serial Port Console Redirection
- 4.5.7 CPU Storage Configuration
- 4.5.8 Onboard Devices Configuration
- 4.5.9 APM Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 HDD/SSD SMART Information
- 4.5.12 USB Configuration
- 4.5.13 Thunderbolt(TM) Configuration
- 4.5.14 PCH-FW Configuration
- 4.6 Boot menu
- 4.7 Tool menu
- 4.8 Exit menu
- 4.9 Server Mgmt menu
- 4.10 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-14
2.7 Hard disk drives (HDD)
The workstation supports three (3) 3.5-inch SATA hard disk drives via the hard disk drive
bays and one 2.5-inch HDD/SSD drive at the bottom of the HDD cage.
Installing 3.5-inch HDDs
To install 3.5-inch SATA hard disk drives:
1. Remove the side cover of the chassis. Refer to the
Removing the side cover
section
for more information.
2. Prepare the 3.5-inch HDD and the bundled set of screws.
3. Locate the HDD cage lock, press the HDD cage lock up (A), then swing the HDD cage
outwards (B) until it clicks in place.
4. Align and insert the 3.5-inch HDD into
the drive bay ensuring that the screw
holes on the HDD matches the screw
holes on the HDD cage.
Screw holes (HDD)
HDD cage lock
HDD cage
Screw hole (HDD cage)