User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Advanced menu
- 4.5.1 CPU Configuration
- 4.5.2 Platform Misc Configuration
- 4.5.3 System Agent (SA) Configuration
- 4.5.4 PCH Configuration
- 4.5.5 PCH Storage Configuration
- 4.5.6 Serial Port Console Redirection
- 4.5.7 CPU Storage Configuration
- 4.5.8 Onboard Devices Configuration
- 4.5.9 APM Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 HDD/SSD SMART Information
- 4.5.12 USB Configuration
- 4.5.13 Thunderbolt(TM) Configuration
- 4.5.14 PCH-FW Configuration
- 4.6 Boot menu
- 4.7 Tool menu
- 4.8 Exit menu
- 4.9 Server Mgmt menu
- 4.10 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-12
2.6 5.25-inch drives
Installing a 5.25-inch drive
To install a 5.25-inch drive:
1. Remove the front panel cover. Refer to
the
Removing the front panel cover
section for more information.
2. Pull the bay locks outward.
3. Remove the metal cover of the bay
you intend to use.
Take extra care when removing the
metal cover. Use tools such as a
screw driver to bend and remove
the metal cover to avoid physical
injury.
This system comes with three 5.25-inch drive
bays located on the upper front section of the
chassis.
If your system came with an optical
drive, the optical drive occupies the
topmost bay (1). The lower bays (2
and 3) are available for additional
5.25-inch optical, zip, or floppy disk
drives.
RESET
Bay locks
Screw driver
Metal cover