User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Advanced menu
- 4.5.1 CPU Configuration
- 4.5.2 Platform Misc Configuration
- 4.5.3 System Agent (SA) Configuration
- 4.5.4 PCH Configuration
- 4.5.5 PCH Storage Configuration
- 4.5.6 Serial Port Console Redirection
- 4.5.7 CPU Storage Configuration
- 4.5.8 Onboard Devices Configuration
- 4.5.9 APM Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 HDD/SSD SMART Information
- 4.5.12 USB Configuration
- 4.5.13 Thunderbolt(TM) Configuration
- 4.5.14 PCH-FW Configuration
- 4.6 Boot menu
- 4.7 Tool menu
- 4.8 Exit menu
- 4.9 Server Mgmt menu
- 4.10 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
ASUS ESC700 G4
5-3
5.1.2 Installing storage devices
The motherboard supports SATA hard disk drives and PCIE SSD storage devices. For
optimal performance, install identical drives of the same model and capacity when creating a
disk array.
Refer to Chapter 2 for details on installing storage devices to your motherboard.
5.1.3 Intel
®
Rapid Storage Technology in UEFI BIOS
To enter the Intel
®
Rapid Storage Technology in UEFI BIOS:
1. Enter the BIOS Setup during POST.
2. Go to the Advanced menu > PCH Storage Configuration, then press <Enter>.
3. Set the SATA Mode Selection item to [Intel RST Premium With Intel Optane System
Acceleration (RAID)].
4. Go to the Boot menu > CSM (Compatibility Support Module) > Launch CSM, then
set the item to [Disabled].
5. Save your changes and exit the BIOS Setup, then enter the BIOS Setup again.
6. Go to the Advanced menu > Intel(R) RSTe SATA Controller then press <Enter> to
display the Intel
®
Rapid Storage Technology enterprise menu.
Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.
Due to chipset limitation, when SATA ports are set to RAID mode, all SATA ports run at
RAID mode together.