User Guide
Table Of Contents
- Notices
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis cover
- 2.2 CPU installation
- 2.3 CPU heatsink and fan assembly installation
- 2.4 System memory
- 2.5 Assembly module
- 2.6 5.25-inch drive
- 2.7 Card reader
- 2.8 Hard disk drives (HDD)
- 2.9 Expansion slots
- 2.10 System fan
- 2.11 BIOS update utility
- 2.12 Motherboard rear and audio connection
- 2.13 Starting up for the first time
- 2.14 Turning off the computer
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- Chapter 5: RAID Configuration
- Appendix
Chapter 3: Motherboard Information
3-6
4. ME firmware force recovery setting (3-pin ME_RCVR1)
This jumper allows you to force Intel Management Engine (ME) boot from recovery mode
when ME become corrupted.
5. Smart Ride Through (SmaRT) setting (3-pin SMART_PSU1)
This jumper allows you to enable or disable the Smart Ride Through (SmaRT) function.
This feature is disabled by default. Set to pins 1-2 to enable it. When enabled, SmaRT
allows uninterrupted operation of the system during an AC loss event.